2020 BMW M division models to receive new 500bhp engine
The 2020 BMW M4 Gran Coupé as imagined by Autocar
Munich squares up to rivals with jacked-up straight-six powerplant in next-generation M3 and M4 models
The flagship model to use this new engine will be a new M4 Gran Coupé (imagined by Autocar above), the first time the four-door coupé has featured a full-fat M variant. It will be joined once again by two-door coupé and cabriolet variants, beside the M3 saloon.
But as M division officials have revealed to Autocar, “it is for all intents and purposes an all-new drivetrain with significant changes to the base engine that allow it to rev beyond 7000rpm and deliver a much higher specific output” than today’s S55 engine.
As well as being earmarked for the next M4 Coupé and the first-ever M4 Gran Coupé, the new twin-turbocharged straight six is also planned to propel a new M4 Convertible, the upcoming sixth-generation M3 and, in a lesser-powered form, the second-generation M2. It will be launched in the new X3M and X4M.
An increase in power provides the new S58 engine with a higher specific output in Competition guise than the old S55 with water injection, a set-up used by the 493bhp M4 GTS.
That unit provides the outgoing M4 Coupé with 425bhp in standard guise and 444bhp in Competition form.
BMW’s M division engineers have managed to raise power by more than 11% in the standard M4 and 13% in the M4 Coupé Competition, with claimed outputs of 473bhp and 502bhp respectively.
Torque is also increased by 37lb ft, with the new S58 engine delivering 442lb ft on a band of revs between 2600rpm and 5600rpm.
Despite the increase in performance, the S58 engine has been developed to meet strict new emission regulations to potentially provide the standard M4 with a CO2 figure of less than 200g/km, thanks in part to the adoption of twin Otto particulate filters.
Key among the changes over the S55 engine is the adoption of a longer stroke, at 90mm. The bore measurement remains 84mm, but BMW M claims the altered internal measurements help to boost torque potential.
Also included are two mono-scroll turbochargers in place of the single twin-scroll unit used on the B58 engine, as well as BMW M’s latest Valvetronic variable valve timing and ‘Double Vanos’ variable camshaft profile. The compression ratio has also been reduced, from 10.2:1 for the S55 to 9.3:1.
Although the new engine goes without water injection, officials say it may appear on a further-developed version of the S58 unit likely to appear in a successor to today’s 453bhp M4 CS.
Secrecy surrounds the rest of the M4’s mechanical makeup. However, insiders suggest it is in line to abandon tradition by adopting an eight-speed torque converter-equipped automatic transmission and a similar xDrive four-wheel drive system to the latest M5 (with an M-Dynamic mode apportioning power to the rear wheels) in at least one version.
It is also suggested a cheaper and lower-powered entry-level model could potentially be offered, with a manual gearbox and rear-wheel drive.
Source: Autocar Online